阮一峰的IT笔记:首页 -> 分类 -> 硬件 查看所有文章:按分类 | 按月份

Canon打印机“废弃墨水吸收器已满”的解决办法

Canon PIXMA iP1000 :Waste Ink Counter Reset Manual for Service mode

1. Turn off the printer. And disconnect the printer cable.
2. Press and hold the POWER button, turn on the printer.
3. The indicator (L.E.D.) should be green.
4. Press and release the RESUME button , the indicator (L.E.D.) should be orange.
5. Press and release the RESUME button again, the indicator (L.E.D.) should be green.
6. Release both buttons.

1、按住 电源 键 插上电源线 。

2、按三次 退纸(就是电源键旁边的那个)键,松开电源键,打印机启动 。

3、打开打印机。

==================

佳能ip系列废墨清零工具

程序适用佳能IP系列机型:
第一步:关闭打印机电源。并把电源线从电源插卒拔开。

第二步:按紧打印机的电源键同时插上电源线。(此时机器电源灯亮)

第三步:不松开电源键。按4下进纸键。电源灯显示:黄--绿--黄---绿。

第四步:松开电源键。机器启动后,电源灯熄灭。

第五步:重新开机。机器开机正常。连接电脑,装好打印的驱动程序。

第六步:打开维修软件。点击GeneralTool图标。出现程序窗口,在usbport项中选择该
打印机所对应的USB端口。在下面的cleaning 和EPROM项前打勾,点击test 1。打印机
电源灯闪动一下。机器已清零重新开机即可。

这是清零软件地址:http://www.100gsoft.cn/soft/sort011/sort027/down-1368.html

先上这个网站下载了程序,然后按着上面的步骤执行问题就解决了,现在打印也不需再按进纸键了。:)

说明:此方法针对于佳能IP1000型号打印机。

« 符合标准的固定在网页中固定位置的广告(转贴) | 首页

About

This page contains a single entry from the blog posted on 2008年05月03日 14:43.

The previous post in this blog was 符合标准的固定在网页中固定位置的广告(转贴).

Many more can be found on the main index page or by looking through the archives.

Powered by
Movable Type 3.33

Post a comment